3,693
edits
(15 intermediate revisions by 3 users not shown) | |||
Line 8: | Line 8: | ||
** Bore and stroke: 55m x 52mm | ** Bore and stroke: 55m x 52mm | ||
** Compression ratio: 9.3:1 | ** Compression ratio: 9.3:1 | ||
* 25mm DellOrto carburetor | * 25mm [[DellOrto]] carburetor | ||
* Kick start (don't let the lights-only battery fool you!) | * Kick start (don't let the lights-only battery fool you!) | ||
* Five-speed | * Five-speed | ||
* Solo seat with folding footpegs | * Solo seat with folding footpegs | ||
* Headlight, high beam, front and rear blinkers, brake light | * Headlight, high beam, front and rear blinkers, brake light | ||
* 50" wheel base | * 50" wheel base | ||
* 187 lb. dry weight | * 187 lb. dry weight | ||
* Top speed 75 MPH | * Top speed 75 MPH | ||
* 6v electrical system, [[Zener diode]] regulated. | |||
* Original Price: $729 | * Original Price: $729 | ||
Line 29: | Line 29: | ||
|} | |} | ||
== | == Parts Manuals == | ||
* [[Newman Indian Mx Frame Assembly Manual]] | |||
* [[Newman Indian 125/5 Engine Assembly Manual]] | |||
== Parts Interchange == | |||
=== Engine === | |||
The Fantic Chopper 125 - ''possibly also the Fantic RC125'' | The Fantic Chopper 125 - ''possibly also the Fantic RC125'' | ||
used the same 125/5 engine as the Indian ME125. | used the same 125/5 engine as the Indian ME125. | ||
=== Turn Signals === | |||
Any single-wire turn signal (chassis ground, hot wire) | |||
with a male M8x1.25 metric threaded connector should fit | |||
the bill. | |||
=== Fuel Petcock === | |||
The zinc fuel petcock tends to crumble into dust after 25 years or so, | |||
and will need to be replaced. | |||
You can replace it with a metric M16x1 female thread petcock, available from many | |||
Italian and German dirt bike suppliers. Unfortunately, most of them | |||
will not ship to the USA. As of this writing, http://www.trebes-motoparts.de | |||
carries several compatible [[Bing]] M16x1 petcocks, and will ship to the US and Canada. | |||
Use Trebes-Motoparts part number 000.009.437 for a Bing M16x1 petcock with a | |||
built in fuel filter. | |||
== Del Orto Carb Adjustment == | |||
The idle screw impacts starting the engine from a cold start, | |||
and is a very tricky adjustment. If you get it wrong, your engine will | |||
not start at all. | |||
It can be reset by turning it all the way in, then unscrewing it | |||
'''two and a half turns'''. | |||
Any further adjustment should be in 1/8 turn increments. It's | |||
an incredibly sensitive adjustment screw. | |||
== Oil Change == | |||
Many 1973/1974 models have an unfortunate design flaw that has lead to the | |||
death of many a kickstart spring. There are '''two''' bolts on the | |||
underside of the engine that look like they are the oil [[drain plug]]. | |||
The bolt immediately under the kickstart lever is the '''kickstart stop''' | |||
bolt - this is what keeps the kickstart from completely unwinding. It is also | |||
the only under-engine bolt visible if the skid plate is installed, as the | |||
'oil drain hole' in the skid plate is in the wrong place, and the | |||
skid plate covers the '''real''' oil drain. | |||
'''DO NOT REMOVE THE KICKSTART STOP BOLT''': You will have to take the | |||
right side engine cover off to fix the kickstart if you do! | |||
Remove the skid plate, and you will find the '''real oil drain plug''' | |||
in the rear-middle of the engine. Unbolt, and drain. | |||
(While you're waiting for the oil to drain, now might be a good time to | |||
make a hole in the skid plate for the real plug.) | |||
Refill the engine with 48oz of SAE 30 Weight Motorcyle wet-clutch compatible | |||
oil, and you should be good to go. '''DO NOT USE DETERGENT MOTOR OILS:''' they will bind up your | |||
wet-clutch. | |||
== "Breaking" the Clutch Plates == | |||
If your clutch plates have seized, you can try to unstick them by: | |||
# Setting the keyswitch to "OFF" | |||
# Squeeze the clutch level firmly | |||
# Kick the kickstart a few times | |||
If the clutch is frozen, you should feel some resistance, and hear the engine go ''blub blub blub'' a few times. When the clutch plates come free, you will feel almost no resistance on the kickstart, and the engine won't make a sound. | |||
== Ignition Switch Settings == | == Ignition Switch Settings == | ||
Line 87: | Line 115: | ||
* 8 oclock - On (no lights) | * 8 oclock - On (no lights) | ||
* 9 oclock - On (lights) | * 9 oclock - On (lights) | ||
* 10 oclock - Park | * 10 oclock - Park (light on) | ||
[[Category:Newell Indian motorcycles| ]] | [[Category:Newell Indian motorcycles| ]] | ||
edits